SOMMER RDC vision - Page 37

37
7.3.4 Operator response to radio command and other command devices with
automatic closing
If automatic closing is activated, each radio command opens the door completely, with
the exception of partial opening.
Aninterimstopisonlypossiblewiththebuttonsfordened"Close,""Stop"anddened
"Open" in the housing.
During automatic closing, the door cannot be closed via a command.
The automatic closing function can be interrupted with the Stop button on the housing
coverorwithanydenedStopcommand.
7.4 Hold to run mode via radio control system
It is also possible to control the operator in hold to run mode via radio control system.
If the safety contact strip is defective, the door can also be operated via radio
control system by pressing and holding it down (hold to run mode). The reaction
in this case is delayed by more than 10 seconds. This operating mode is only to
be used in the event of an emergency, is not designed to be a permanent solution
and is only suitable when the user can see the door.
7.5 Buttons and LEDs
STAUS
SAFETY
RADIO
START
RADIO
DSL
2345678
DIP
ON
ON
ON
Keyboard
STAUS
RADIO
SAFETY
START
RADIO
3
4
5
2
7
6
1
1. Direction of motion LED
"Close"
2. Direction of motion LED
"Open"
3. Status LED
4. Radio LED
5. Safety LED
6. Start button
7. Radio button