Need help?Do you have a question about the Sommerkamp TS-5030P and is the answer not in the manual?
Details dimensions, weight, power consumption, finish, controls, and components.
Lists frequency range, sensitivity, selectivity, and other receiver parameters.
Details frequency range, power output, modulation, and impedance.
Explains the AM/A3 signal reception and filter design.
Describes the AM/A3 signal transmission, oscillators, and output stages.
Details power supply components and clock functionalities.
Details the chassis, panels, and cabinet materials used.
Lists the available connectors like AC cord, UHF, microphone, and headphone.
Provides step-by-step instructions for initial setup and verification.
Instructions for switching on, selecting channels, and transmitting.
Explains the functions of the clock knobs for ON/OFF, AUTO, SLEEP, and alarm.
Recommendations for antenna types and installation for optimal performance.
Procedures for checking voltages and aligning the power supply unit.
Steps to test and verify the audio frequency amplifier performance.
Procedures for checking crystal oscillator frequencies and output voltages.
Steps for checking sensitivity and alignment of the receiver section.
Procedures for testing and aligning the transmitter output and modulation.
Mounting side view of the printed circuit board for the linear amplifier.
Mounting side view of the printed circuit board for the voltage regulator.
Mounting side view of the printed circuit board for the transceiver unit.
General| Power Output | 100 watts |
|---|---|
| Voltage | 13.8 V DC |
| Power Supply | 13.8 V DC |
| Type | Transceiver |
| Modes | SSB/CW |
| Output Power | 100 watts |
To Next Page