EasyManua.ls Logo

Sonance MAG 5.1 PREMIUM - MS10 Sub - Volume Control; Volume Control Adjustment; MS10 Sub - Auto-On; Auto-On Functionality

Sonance MAG 5.1 PREMIUM
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
MS10 SUB - VOLUME CONTROL
The volume control on the rear panel of the MS10 SUB (Figure 7:)
should normally be set to the MAX or FULL CLOCKWISE setting.
A/V home theater receivers have built in settings for volume
level for subwoofer and satellite speakers. The settings for
the volume volume can be adjusted in the on screen menu for
your A/V home theater receiver. By setting the MS10 SUB in
this way the correct output level will be applied in your A/V
home theater receiver and not in the subwoofer.
Further adjustment of the subwoofers level can be made
using the built in Volume Control. When setting the
subwoofer’s Volume Control by ear, try to find a volume
setting where the bass sounds balanced on both music and
films. Listen to several dierent music recordings and film
soundtracks that contain strong bass passages and try to find
a setting for the Volume Control that doesn’t over-emphasize
the bass or make it sound weak.
MS10 SUB - AUTO-ON
The subwoofer is in the STANDBY mode whenever its power
cord is plugged-into a live AC outlet. When the subwoofer
detects an audio signal it will automatically turn ON
(the rear-panel On/Standby Indicator will illuminate blue).
The subwoofer will continue to remain ON for approximately
15 minutes after no signal is detected on its input, then it will
return to STANDBY (the rear-panel On/Standby Indicator will
illuminate red).
STATUS
LINE LEVEL INPUT
VOLUME
MIN MAX
CROSSOVER
50 HZ
250 HZ
150 HZ
75HZ 200 HZ
BYPASS
0 DEG 180 DEG
90 DEG
PHASE
RIGHTLEFT / LFE
GROUND LIFT
GROUNDED
ISOLATED
100 -120V 220 –240V
FUSE T4 AL / 250 VAC
AC 1 00-120V ~ 60Hz
AC 2 20-240V ~ 50Hz
ON
OFF
POWER
S/ N
MADE IN CHINA
This device complies with part 15 of the FCC
Rules.
Operation is subject to t he following two
conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
receiv ed, including interference that may c ause
undesired operation.
FCC COMPLIANCE NOTICE
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
RISQUE DE CHOC ELECTRONIQUE NE PAS OUVRIR
AVIS
GMA-503573-EA
MS10SUB
Sonance
Subwoofer
FIGURE 7: MS10 SUB ADJUSTMENTS

Related product manuals