Sonance Mariner 51 - User Manual

To Next Page

INTRODUCTION

Thank you for purchasing Sonance Mariner weather-resistant speakers.

When properly installed, these speakers will give you many years of

outdoor entertainment pleasure. To get the most out of your new

speakers, please read this manual thoroughly before you begin installation.

The directions in this manual apply to the following models:

• Mariner 82 • Mariner 61

• Mariner 63 • Mariner 52

• Mariner 62 • Mariner 51

PARTS LIST

Your Sonance Mariner speaker box includes the following:

SPEAKER PLACEMENT

Mariner speakers are highly weather-resistant, and when mounted

outdoors will perform exceptionally well for years even under adverse

weather conditions.

The new Mariner FastMount

bracket system makes it easy to mount the

speakers in a variety of positions and locations:

The best performance is obtained by placing the speakers at ear level,

facing the listeners.

• If you are mounting the speakers above or below ear level, pivot them

up or down to direct the sound towards the listeners.

• You can orient the speakers either horizontally or vertically without

affecting the sound quality.

CONNECTING AND ASSEMBLING THE SPEAKERS

WARNING: Turn the amplifier’s power OFF until you have

completed all of the connections and have determined that they are

correct. (If the amp’s AC plug is accessible we recommend that

you unplug it from the wall outlet to avoid accidental turn-on and

possible damage to the amplifier.)

1. In most cases you will be able to

attach the FastMount brackets

directly to the mounting surface.

Run the speaker wires from the

amplifier to the speaker locations

and through the holes in the

brackets (and mounting bases, if

used).

Note: To increase water resistance

and make installation easier, the

speaker wire terminals are located on

the Mariner speakers’ front panel. Be

sure to leave enough wire at the

speaker location to feed through the

tunnel in the speaker enclosure and

connect to the terminals on the front.

2. Attach the FastMount brackets to the mounting surface using

hardware (not included) that is appropriate for the type of surface.

• If the installation requires that

the speaker be mounted in a

corner, attach the bracket with

hardware through the slots in

the angled corners as shown

to the right.

INSTRUCTION MANUAL

SONANCE LANDSCAPE SERIES

MARINER

OUTDOOR SPEAKERS

(2) Sonance Mariner speakers

(2) Grilles

(2) Wiring terminal covers

(2) FastMount™ Brackets

(4) Mounting bracket base halves

(2) Plastic inserts (to fill bracket

indentations when mounting

brackets are not used)

(1) Hardware package

Against a wall

(angled, with base)

Under an eave

On a pole

In a corner

Against a wall

(flush)

2. Attach

bracket

1. Pass wire

through hole

3. Corner

mounting

Other manuals for Sonance Mariner 51

Brochure8 pages

Need help?

Do you have a question about the Sonance Mariner 51 and is the answer not in the manual?

Sonance Mariner 51 Specifications

General

Brand	Sonance
Model	Mariner 51
Category	Speakers
Language	English

Summary

Introduction to Sonance Mariner Outdoor Speakers

Models Covered

Lists the specific Sonance Mariner outdoor speaker models this manual applies to.

Parts List

Details all components included in the Sonance Mariner speaker box for installation.

Speaker Placement and Mounting

Optimal Placement

Guidance on positioning speakers at ear level for best sound quality and pivoting for direction.

Mounting Options

Illustrations and descriptions for mounting speakers against a wall, under eaves, or on poles.

Connecting and Assembling Speakers

Wire Management and Bracket Attachment

Instructions for passing speaker wires through brackets and attaching them to the mounting surface.

Using Mounting Bases

Steps for attaching mounting bases for vertical or horizontal pivoting and securing the bracket.

Connecting Wires to Terminals

Detailed guide on stripping wires, opening connectors, inserting wires, and securing them.

Important Connection Safety

Critical warning to double-check wiring and avoid short circuits to prevent amplifier damage.

Speaker Finishing and Adjustments

Painting Speakers and Grilles

Instructions for painting the weather-resistant enclosure and grille for custom aesthetics.

Pivoting the Speaker

Procedure for unlocking, rotating, and locking the speaker on its bracket for optimal sound direction.