4. Use a wire tie to keep the wire loop intact and act as a
strain relief.
PLEASE NOTE: regarding the 4 colored wires, the Red (+)
and Black (-) are used for the Right channel, White (+) and
Green (-) for the Left channel.
5. Cutting the wires. In this example, we want the first speaker
to be connected to the right channel so we cut the Red (+) and
Black (-) wires only. Leave the White and Green wires intact.
6. Strip off 1 inch (25.4mm) of insulation on Red and Black wires
to expose the copper conductor. Combine and twist the Red
wires from the amplifier, the first satellite and the wire run
running to the next speaker in a clock-wise motion.
7. Secure these three wires using the provided Silicone Filled
Wire Nuts.
5
To Next Page
Loading...
