4. Pull on the suction cup to ensure that it is holding securely, then route the
transducer cable up to the carrying case. Restrain the cable so that it does not
become tangled in the propeller or the motor workings.
IMPORTANT: Suction cups can come loose. Be sure to take the time
to tie a rope to the transducer bracket and then to the boat leaving
as little amount of slack as you can. If the cup comes lose, this
will keep your transducer and cable out of the propeller.
Turning the SP300 On
press the master ON/OFF switch for about 2 seconds to turn the T-box
on.
(Note: random flashing of the power light is normal and indicating
it is transmitting a WiFi signal)
Charging the Battery
Allow the battery to warm up before charging. This makes it easier
for the charger to charge the battery and the battery is more
accepting of a charge.
1. Plug the charger into a wall outlet, verify that it is operating by noting the
illuminated GREEN light.
2. Connect the charger to the Easy Charge Jack on the SP300. The charger’s light will
switch to RED, indicating that it is connected correctly and the battery is
charging.
3. Keep the charger plugged in and connected until the RED light has changed to GREEN.
This indicates the battery is at full charge.
4. Unplug the charger from the wall outlet and disconnect from the battery.
Charging times will vary depending on how much the battery has been
drained. If the battery has been completely drained the battery
To Next Page
Loading...
