Cover
UV sanitzer
UV lamp
DC plug
Charging peg
Upper
Lower
Q1 Q2
Q3 Q4
To Sterilize Brush Heads: Place brush heads on the
brush head peg inside the UV sanitizer with the
bristles facing the UV lamp. When the cover is
closed, the UV lamp will light up and sterilization will
start. After 3-5 minutes, the UV lamp will turn off.
Sterilization will start every time the case is
opened/closed. If lamp does not turn on after closing
case, wait 30 seconds and open/close the case again.
Lamp should start if everything is properly connected.
Warnings:
• It is not necessary to exert much pressure or move the toothbrush in the usual tooth
brushing motion while brushing teeth with the Sonic-FX toothbrush. Slightly press brush head
onto the surface of the teeth and allow the ultrasonic vibrations to clean and polish the
teeth while moving the brush head up and down gently over all tooth surfaces, one quadrant
at a time. Pressing too hard or brushing in one spot for too long may harm teeth or gums.
• Do not use in combination with tooth abrasives.
• To avoid spray, place brush head in mouth before pressing power button.
• To avoid button malfunction, press buttons with pad of finger only, not fingernails.
To Use Sonic-FX Toothbrush: Wet brush head
with water and add toothpaste. First put the brush
head in your mouth and then press power button
to start. Press mode button to change modes from
Super (high speed) to Normal (medium speed) to
Massage (alternating speeds). Start brushing teeth
and continue for 2 minutes using the Quadrant
Method as shown, in which you brush each
quadrant of the mouth for 30 seconds. Sonic-FX
will notify you every 30 seconds with a unique
vibration or pause after each 30-second interval.
Press power button to stop. Store toothbrush on
charging peg between brushings.
Quadrant
Method:
Divide the
mouth into 4
quadrants as
shown and
brush each
quadrant for
30 seconds.
Warnings:
• Store product out of reach of children.
• Avoid looking at the UV sanitizer while lamp is on.
• Avoid exposure to the UV lamp while lamp is on.
• Do not allow UV lamp to come in contact with water.
• Cover must be properly closed or it will not function correctly.
Note:
• This product is intended for normal household use. Do not use for commercial,
professional or any other use.
To Next Page
Loading...