2
Safety and Regulatory Information
Mounting the Appliance
Flat Surface Option
Place the TZ on a flat surface. Allow unrestricted airflow around the unit, leaving a minimum of 1 inch
(25.44mm) clearance on all sides.
Rack Mounting Option
SonicWall offers a rack mount tray kit for mounting your TZ and power adapter(s) in a standard 19-inch rack.
Installing the Appliance
WARNING: The following conditions are required for proper installation.
• Install in a location away from direct sunlight and sources of heat. A maximum ambient temperature
of 104ºF (40º C) is recommended.
• Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,
transmitters, and broadband amplifiers.
• The included power cord(s) are approved for use only in specific countries or regions. Before using a
power cord, verify that it is rated and approved for use in your location.
• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum
of 1inch (25.44mm) clearance is recommended.
• Consideration must be given to the connection of the equipment to the supply circuit. Appropriate
consideration of equipment nameplate ratings must be used when addressing this concern. Do not
overload the circuit.
• Reliable grounding of power supply must be maintained. Particular attention must be given to power
supply connections other than direct connections to the branch circuits, such as power strips.
To Next Page
Loading...
Need help?
General