Do you have a question about the SonicWALL SOHO APL31-0B9 and is the answer not in the manual?
Model | SOHO APL31-0B9 |
---|---|
Category | Network Router |
Wireless | No |
VPN Support | Yes |
Max VPN Tunnels | 10 |
Encryption | 3DES, AES |
Interfaces | 4 x 10/100Base-TX LAN ports, 1 x 10/100Base-TX WAN port |
Dimensions | 190 x 140 x 35 mm (7.48 x 5.51 x 1.38 in) |
Identifies and describes the ports and indicators on the front panel of the SonicWall SOHO appliance.
Identifies and describes the ports on the back panel of the SonicWall SOHO appliance.
Connect the power adapter and cable, then plug into an outlet to power on the device.
Use only the included power adapter; do not use a damaged or different adapter.
Connect the WAN interface (X1) to your Internet connection using an Ethernet cable.
Connect the LAN interface (X0) to your computer using an Ethernet cable.
Navigate to https://192.168.168.168 in your web browser and click the setup wizard link.
Log in with default credentials (admin/password) and change the password if desired.
Follow the prompts to configure Time Zone, WAN/LAN settings, DHCP, and port assignments.
Point browser to the appliance LAN IP address (default https://192.168.168.168) and log in.
Create a MySonicWall account or log in to register the appliance and manage services.
Note serial number and authentication code for manual registration on the SonicWall website.
Navigate to mysonicwall.com, select SOHO Firmware, and download the desired file.
On the appliance, go to System > Settings, click Upload New Firmware, browse, and select the file.
After upload, click the Boot icon for the new firmware in the Firmware Management Table.
Drill holes, insert anchors if needed, use screws leaving 5/32 inches exposed, and slide appliance on.
Specifies screw types and wall anchors for mounting on drywall or solid wood/metal.
Install away from sunlight, heat, and sources of noise; ensure proper airflow and cable routing.
The lithium battery is not user-replaceable; return appliance to an authorized service center.
Ethernet and RS232 cables are for intra-building use only; do not connect to external wiring.
Use only a UL listed power supply (I.T.E. LPS) with 12V DC, min 2.0A, Tma min 40°C.
Information on conformity declarations and where to find CE declarations online.