With the product built-in temperature sensor, real-time maximum temperature of the
entire product can be detected and speculated, which prevents the product from
deformation, melting, fire or live devices exposing in case of over-temperature.
The device automatically cuts off the load when it gets too hot. To exit the overheating
protection mode, simply press the button on the device after confirming that the load is
functioning normally without any internal shorts, excessive power, or leaks.
*Please note that this function only serves as auxiliary protection and cannot be used in
place of a circuit breaker.
Change the device's network by "Wi-Fi Settings" in the "Device Settings" page on the eWeLink
App.
Reset the device to factory settings by "Delete device" in the eWeLink App.
1. Make sure the device is in pairing mode.
The device will automatically exit the pairing mode if it is not paired within 10mins.
2. Please enable location service and allow access to location permission.
Before connecting Wi-Fi network, please enable the location service and allow access to
the location permission. Location information permission is used to obtain Wi-Fi list
2.Auxiliary overheating protection
Device Network Changing
Factory Reset
FAQ
Fail to pair Wi-Fi devices with the eWeLink App
To Next Page
Loading...
