9
Bind Temperature Control Device
There is a built-in temperature sensor in the NSPanel to monitor the room temperature
and you can maintain the room temperature by controlling the cooler/heater, which is
connected with smart switches or smart plus and these devices are required to pair with
eWeLink App.
Access the NSPanel interface in the App and tap “Thermostat” to select the devices in the
Action device list. All the listed devices are supported to bind with the Thermostat
(including two NSPanel channels). You can only select one device or one channel of the
multi-channel device to execute and then choose heater or cooler as the Device type.
Active the Thermostat after selecting the Action device and Device type, then you can see
there are two modes to control the temperature which are Manual mode and Auto mode.
Manual mode:
Allow you to adjust the temperature manually whenever you want and then the
Thermostat will execute to maintain the manual setting temperature.
Auto mode:
Allow you to set 6 target temperature at most by tapping “Add” to se the temperature
respectively. Once set, all setting will execute automatically at certain time duration and
cannot be controlled manually unless switched to the Manual mode. The binding devices
will turn off when they are out of schedule.
Actual room temperature will be ±1°C. For example, the setting temperature is 26°C
but the actual temperature range is between 25°C and 27°C.
To Next Page
Loading...
Need help?
General
