LP Gas Cylinder Installation
1. The gas supply must be turned off at the LP gas supply cylinder when this gas grill is not in
use.
2. Storage of this gas grill indoors is permissible only if the cylinder is disconnected and
removed from the gas grill.
3. Cylinders must be stored outdoors out of reach of children and must not be stored in a
building, garage, or any other enclosed area.
LP Gas Cylinder installation:
1, Pull the Cylinder lock ring up and put the
cylinder in the hole on the cart base.
(See Fig. 25)
2, Put the ring on the neck of the cylinder to
lock the cylinder on position.
(See Fig. 26)
Fig. 26
Fig. 25
Cylinder lock ring
▲ WARNING
A frosty cylinder valve indicates possible gas over fill. Close the LP valve and call your dealer
immediately.
▲ WARNING
1. Never store any extra cylinder under or near your grill.
2. Never fill your cylinder over 80% full by weight. This may cause release of gas from the safety
relief valve.
3. If the information in points 1 and 2 above is not followed exactly, a fire causing death or
serious injury may occur.
To Next Page
Loading...
