Sonoro ORCHESTRA - User Manual

Questions and Answers

J
John HernandezJul 29, 2025
What to do if Sonoro ORCHESTRA have no sound?
- C
  Christina CooleyJul 29, 2025
  If your Sonoro Speakers have no sound, it could be due to an amplifier problem or improperly connected speaker cables. First, connect a known working loudspeaker to the amplifier outputs and verify that all electronics are on, the signal routing is correct, the source is active, and the volume is turned up. Also, check that all the connected cables between the amplifier and the speaker terminal are properly connected.
C
cwoodAug 6, 2025
Why do Sonoro ORCHESTRA have constant noise like buzzing or humming?
- K
  Kristin HopkinsAug 6, 2025
  Constant noise such as buzzing or humming in your Sonoro Speakers can be due to poor grounding of the amplifier or a faulty cable. You should check and correct the amplifier grounding problem. If the grounding is correct, replace the existing cable with a good one.
J
James QuinnAug 13, 2025
What to do if Sonoro Speakers have intermittent output such as cracking or distortion?
- S
  Sarah BrownAug 13, 2025
  If your Sonoro Speakers have intermittent output, such as cracking or distortion, the speaker cables may not be connected properly. Check all connectors at the amplifier and speaker to ensure they are correctly connected and tight.
T
Tyler RodriguezAug 21, 2025
How to fix poor low frequency response on Sonoro Speakers?
- L
  laurenmclaughlinAug 21, 2025
  A poor low frequency response in your Sonoro Speakers can be caused by speaker cables wired in the wrong polarity. Ensure the amplifier (+) terminal is connected to the speaker’s (+) terminal, and the amplifier (–) terminal is connected to the speaker’s (–) terminal.