1 Use the wall mount bracket to mark
screw locations. Align the top edge
with the bottom of your TV. There
should be 5.5 in (14 cm) between the
top of the wall mount bracket and the
TV.
Mark the screw locations and remove
the wall mount bracket for now.
2 If you’re using the included wall
anchors, use a 5/16 in / 8 mm drill bit
to drill the pilot holes and then insert
the wall anchors. Don’t use the
anchors if you’re drilling into wood or
plastic.
3 Position the wall mount bracket over
the marked screw locations, using a
level to confirm accuracy. Use a
Phillips-head screwdriver or a power
drill to screw the bracket to the wall,
making sure the arrows in the center
are pointing up.
4 Screw the 2 knobs (thumb screws)
into the back of the soundbar until
they are fully tightened.
To Next Page
Loading...
