Sonos ZP100
11
ZP100 Rear Panel Connectors
Ethernet switch connectors (4) Use Category 5 Ethernet cable to connect to a router, computer, or additional network
device such as a network-attached storage (NAS) device.
LED indicators:
•
Green (link connection)
•
Flashing Yellow (network activity)
Right speaker terminals Use high-quality speaker wire to connect the right speaker to the ZP100.
Left speaker terminals Use high-quality speaker wire to connect the left speaker to the ZP100.
Voltage select 115V/230V
Select the appropriate voltage setting for your country.
AC power (mains) input Use the supplied power cord to connect to power outlet.
Analog audio out (fixed/variable) You may use a standard RCA audio cable to connect the audio inputs on a separate audio
component such as an amplifier or your home theater receiver, to the ZP100’s analog
audio outputs.
Analog audio in You may use a standard RCA audio cable to connect the ZP100’s analog audio inputs to
the audio outputs from a separate audio component, such as a CD player or a portable
music player.
Subwoofer output
Note: If you disconnect your subwoofer, make sure to
also disconnect the subwoofer’s cable from the
ZP100 output.
You may connect a powered subwoofer to this output using a standard RCA cable. The
system will detect when a cable is connected to the subwoofer output and adjust the
crossover frequency automatically.
To Next Page
Loading...
