18
Step 3: Preparing for
Network Connection
If you are not going to connect the player
to a network, proceed to “Step 4: Easy
Setup” (page 18).
Use a LAN cable to connect to the LAN
(100) terminal on the player.
z
Using a shielded interface cable (LAN cable),
straight or crossing, is recommended.
Use the wireless LAN that is built into
the player.
Step 4: Easy Setup
1 Insert two Size AA (R6) batteries
by matching the 3 and # ends on
the batteries to the markings
inside the battery compartment.
2 Plug the player into the AC outlet.
3 Press [/1 to turn on the player.
4 Turn on the TV and set the input
selector on your TV. This will
show the signal from the player
on your TV screen.
Wired Setup
Wireless Setup
ADSL modem/
Cable modem
Broadband
router
LAN cable
(not supplied)
Internet
Wireless LAN
router
ADSL modem/
Cable modem
Internet
LAN cable (not supplied)
When turned on for the first time
Wait for a short while before the
player turns on and starts [Easy
Initial Settings].
to AC outlet
To Next Page
Loading...
