Settings and Adjustments
45
GB
[Network Settings]
x [Internet Settings]
Connect the system to the network beforehand.
For details, see “Step 3: Preparing for Network
Connection” (page 19).
[Wired Setup]: Select this when you connect to
a broadband router using a LAN cable.
[USB Wireless Setup]: Select this when you use
a USB Wireless LAN Adapter for wireless
network connection.
[View Network Status]: Displays the current
network status.
•For further details, visit the following website and
check the FAQ:
For customers in Europe and Russia:
http://support.sony-europe.com/hub/hub.html
For customers in other countries/regions:
http://www.sony-asia.com/section/support
x [Network Connection Diagnostics]
You can run the network diagnostic to check if
the network connection has been made properly.
x [Connection Server Settings]
Sets whether or not to display the connected
DLNA server.
x [Renderer Set-up]
[Automatic Access Permission]: Sets whether or
not to allow automatic access from a newly
detected DLNA controller.
[Smart Select]: Allows a Sony DLNA controller
to find the system as the target component to
operate by using the infrared ray. You can set
this function to on or off.
[Renderer Name]: Displays the system’s name
as it is listed on other DLNA devices on the
network.
x [Renderer Access Control]
Sets whether or not to accept commands from
DLNA controllers.
x [PARTY Auto Start]
[On]: Starts a PARTY or joins an existing
PARTY at the request of a networked device
compatible with the PARTY STREAMING
function.
[Off]: Off.
x [Media Remote Device Registration]
Registers your “Media Remote” device.
x [Registered Media Remote Devices]
Displays a list of your registered “Media
Remote” devices.
[Easy Setup]
x [Easy Initial Settings]
Runs [Easy Initial Settings] to make the basic
settings. Follow the on-screen instructions.
x [Easy Network Settings]
Runs [Easy Network Settings] to make the basic
network settings. Follow the on-screen
instructions.
[Resetting]
x [Reset to Factory Default Settings]
You can reset the system settings to the factory
default by selecting the group of settings. All the
settings within the group will be reset.
x [Initialize Personal Information]
You can erase your personal information stored
in the system.
To Next Page
Loading...
