+ .
To ensure clearpictures,clean the \ddeo heads. When 0 appears in the viewfinder in CAMERA mode or
playback picturesare "noisy" or hardly visible,the _ideo heads may be contaminated.
[a] _ ,-- [b]
[a] Slight contamination
[b] Critical contamination
If this happens, clean the video heads with the Sony VS-2._LH cleaning cassette (not supplied). After
checking the piCtUre, if it is still "noisy", repeat the cleaning. (Do not repeat cleaning more than 5 times.)
Caution
Do not use a commercially available wet-_,pe cleaning cassette. It may damage the video heads.
Note
If the VS-25CLH cleaning cassette is not available in )'our area, consult your nearest Sony dealer,
' Remov|ng Dus_from inside"the viewfinder .....
(1) Remove the screw with a sox_wdriver (not supplied). Then, while sliding the RELEASEknob, turn
the eyecup in the direction of the arrow and pull it out.
(2) Clean the surface with a commercially available blower.
21
@
To Reattach the Eyecup
(1) Align the groove on th eyecup with the • mark on the barrel.
(2) Turn the eyecup in the direction of the arrow. Then, replace the screw.
2
Caution
Do not remove any other screws. You may remove only the screw to remove the eyecup.
36 37
To Next Page