Sony CDP-211 - Page 5

SECTION 2
DISASSEMBLY
Note: Follow the disassembly procedure in the numerical order given.
FRONT PANEL REMOVAL
When removing the front panel assembly on electric power
failure, first open the loading block by turning cam with a
screwdriver as shown in the figure, next pull out the loading
block with hand, and remove the loading panel as shown in the
figure. Then remove the front panel assembly.
© Remove loading panel to the
direction of arrow.
MD (BU-5BD10) REMOVAL
ooe
Turn the cam to the direction of arrow (Counter clock wise)
by minus screw driver.
Take off the disc table.
Remove the yoke bracket.
Remove the MD (BU-5BD10) to the direction of arrow.
Cam
@ Turn the cam to the
direction of the arrow
with screwdriver.
Note: Keep the set horizontal.
Yoke bracket
BU-5BD10 i
8
\
Disc table