4 To program other discs or tracks, do the following:
To program Repeat Step(s)
Other discs 2
Other tracks on the same disc 3
Other tracks on other discs 2 and 3
5 Press r> to start Program Play.
TocancelProgram Play
Press CONTINUE.
Checking the track order
You can check your program before or after you start
playing,
Press CHECK.
Each time you press this button, the display showsthe
track (the disc and track numbers) or the disc (the disc
number and "AL" indication) of each step in the
programmed order. After the last step in the program,
the display shows "End" and returlds to the original
display. If you check the order after you start playing,
the display shows only the remaining steps.
"_° You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 5 with
pressing DISC SKIP to check the disc labels. If you close
the disc tray before Step 5, the total playing time appears
in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
The program remains even after the Program Play
ends
When you press E>-, you can play the same program
again.
Theprogram remains until you erase it or turn off the
player
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
Note
The total playing time doesn't appear when:
--You have programmed a track whose number exceeds 20.
--The total playing time of the program exceeds 200 minutes.
Changing the track order
You can change your program before you start playing.
To Press
J
Erase a track CHECK until the track you
don't want appears in the
display, then press CLEAR
Erase the last track in the CLEAR. Each time you press
program the button, the last track will
bedeared.
Add tracks to the end of the DISC 1 - 5 to select the disc,
program then number buttons of the
tracks to be added
Change the whole program
completely
CLEAR until "ALL CLr"
appears in the display.
Create a new program
followingtheprogramming
procedure.
12
To Next Page
Loading...
