Sony CDP-CX205 - Page 14

14
Playing CDs
Creating a program using the remote [7]
PROGRAM
Number
buttons
ENTER
CLEAR
Press PROGRAM.
Press DISC.
Press the number button of the disc.
b W N a
To program a whole disc, skip this step and go to
Step 6. Press TRACK.
5 Press the number button of the track.
6 Press ENTER.
7 To program other discs/ tracks, do the following:
To program Repeat Steps
Other discs 2, 3 and 6
Other tracks on the same disc — 4to6
Other tracks on other discs 2to6
8 Press D> to start Program Play.
To cancel Program Play“
Press CONTINUE.
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
“AL” appears instead of the track number.) After the
last step in the program, the display shows “End” and
returns to the original display.
Changing the programmed order
You can change your program before you start playing.
To You need to
Erase a track or disc Press CHECK until the track or
disc you do not want appears in
the display, then press CLEAR
Erase the last track or
disc in the program
Press CLEAR. Each time you
press the button, the last track or
disc will be cleared.
Add tracks or discs to the Follow the programming
end of the program procedure
Hold down CLEAR until “All
Clr” appears in the display to
erase the whole program, then
create a new program following
the programming procedure
Change the whole
program completely
Erasing the program stored in memory
1 Press PROGRAM in the stop mode.
2 Hold down CLEAR until "All Clr” appears in the
display.