Sony CDP-CX260 - Locating Discs and Tracks; Locating a Specific Disc

– 16 –
GUIDE (DISC T) ALIGNMENT
Cam
Cam Holder (guide T)
Fixed screw
Guide (disc T)
Guide (disc T)
Guide (disc T)
Disc
Disc
Holder
(guide T)
Holder (guide T)
Tapering screwdriver
A
B
(1) Rotate the cam and adjust to the
position shown in the figure.
(2) Check that the state is as
shown in the figure.
(3) Loosen the fixed screw by about 60 °.
(4) Move the holder (guide T) with a tapering screwdriver,
and set the position of the guide (disc T) to A:B=1:1.