Sony CDP-CX270 - Page 20

20
Playing CDs
3 Press the number button of the disc.
PROGRAM
*DISC-20x
4 To program a whole disc, skip this step and go to
Step 6. Press TRACK /SPACE.
ees 20
xDISC-20*
TRACK- FE 3.)
5 Press the number button of the track.
PROGRAM!
*DISC-20x
6 Press ENTER.
The track being programmed
The disc being
programmed
Playing order
7 To program other discs/ tracks, do the following:
To program Repeat Steps
” Other discs 2,3 and 6
Other tracks on the same disc 4 through 6
Other tracks on other discs 2 through 6
8 Press > to start Program Play.
To cancel Program Play
Press CONTINUE.
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the front panel display
shows the disc and track numbers of each step in the
programmed order. (When a whole disc is
programmed as one step, “ALL” appears instead of the
track number.) After the last step in the program, the
front panel display shows “END” and returns to the
original display.
Changing the programmed order
You can change your program before you start playing.
To
You need to
Erase a track or disc
Press CHECK until the track or
disc you do not want appears in
the front panel display, then press
CLEAR
Erase the last track or
disc in the program
Press CLEAR. Each time you
press the button, the last track or
disc will be cleared.
Add tracks or discs to the Follow the programming
end of the program
procedure
Change the whole
program completely
Hold down CLEAR until “ALL
CLEAR” appears in the front
panel display to erase the whole
program, then create a new
program following the
programming procedure
Erasing the programs stored in memory
1
Press PROGRAM repeatedly in the stop mode
until the program number (PROGRAM 1, 2 or 3)
you want to erase appears in the front panel
display.
Hold down CLEAR until “ALL CLEAR” appears
in the front panel display.