– 16 –
GROUP1
GROUP4
PAUSE button
PLAY button
Fixed screws
Swing
Holder (table sensor)
Table assembly
At this position,this
part will be locked.
Sensor Adjustment
1. With the power ON, while pressing the GROUP 4 and ·
buttons, press the +100 button to enter the mechanism adjust-
ment mode.
2. Press the GROUP 1 button to operate the loading mechanism,
and continue pressing until the disc table locks. (Fig-3)
3. Loosen the fixing screw, move the holder (TABLE SENSOR)
slightly, and when the LED (green) of the PLAY button switches
to the LED (orange) of the PAUSE button (or vice versa), se-
cure the holder (TABLE SENSOR). (Fig-4)
4. Moving the disc table right and left with a hand after the screw
is fixed, the table will move by the play of a disc table. If the
LEDs light up alternately, the adjustment will be performed cor-
rectly. (Fig-4)
FIg-3
FIg-4
PLAY indicator
Linked with
·
indicator
Linked with
P
indicator
PAUSE indicator
To Next Page
Loading...
