— 29 —
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS
AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each
block.)
NOTE
• : parts extracted from the component side.
• : parts extracted from the conductor side.
• : Pattern from the side which enable seeing.
• p : parts mounted on the conductor side.
• : Solder bridge
NOTE
• All capacitors are in µF unless otherwise noted. pF : µµF 50WV
or less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and 1/4W or less unless otherwise speci-
fied.
• : panel designation.
• B+ : B+ Line
•
B– : B– Line
• Voltage and waveforms are dc with respect to ground under no-
signal conditions.
no mark : STOP
• Voltages are taken with a VOM (Input impedance 10MΩ).
Voltage variations may be noted due to normal production tol-
erances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production tol-
erances.
• Circled numbers refer to waveforms.
• Signal path.
: CD
: CD (digital)
• Abbreviation
CND : Canadian model.
SP : Singapore model.
AUS : Australian model.
IC501 #¡ EXTAL
10MHz
IC102 @¡ PCK
4.32MHz
IC102 $¢ XOUT
33.867MHz
IC102 ^º 16M
33.867MHz
IC102 ^¡ 4.2M
4.23MHz
(PLAY)
IC101 $¡ RFSM
1.4Vp-p
(PLAY)
IC101 @º FE
APPROX 400mVp-p
2.5V
APPROX 1Vp-p
(PLAY)
IC101 7 TE
BD SECTION
• Waveforms
MAIN SECTION
Note:
The components identi-fied
by mark ! or dotted line with
mark ! are critical for safety.
Replace only with part num-
ber specified.
Note:
Les composants identifiés par
une marque ! sont critiques pour
la sécurité.
Ne les remplacer que par une
pièce portant le numéro spécifié.
1
2
3
4
5
6
5.8Vp-p
5.2Vp-p
5.5Vp-p
7
5.6Vp-p
1
4.3Vp-p
To Next Page
Loading...
