Sony CDP-M39 - Troubleshooting Guide; Disc Tray and Playback Issues; No Sound or Display Errors; Remote Commander and General Operation Problems

Bicelele) (= alereliiale mest iel-)
Before
going
through
the
check
list
below,
first
refer
back
to
the
connections
and
operating
procedures.
Should
any
problem
persist
after
you
have
made
these
checks,
consult
your
nearest
Sony
service
facility.
Symptom
Cause
cae
Remedy
The disc tray does not close.
The disc is not placed correctly.
Place
the
disc
correctly
on
the
disc
tray.
Play does not start. Dirty disc.
Clean the disc.
The disc is inserted upside down.
Insert
the
disc
with
the
printed
side
up.
The player is in the pause mode.
Press HE (or I on the remote
commander)
to
release
pause.
Moisture condensation.
Leave the player turned on for
approximately one hour.
“NO DISC” displayed
There is no disc in the unit.
Insert a disc.
Sound is not heard.
Loose connection.
Insert the plug firmly.
Connection is incorrect.
Check
the
connection
referring
to
“Connecting
the
CD
Player’.
The LEVEL control is set to the
minimum.
Turn
the
control
clockwise.
17 is displayed when you press PP.
bP was continuously pressed at the
end of the disc.
Press << or Ké<d to return to normal
indication.
The remote commander does not
operate the unit.
The batteries are run down.
Replace both batteries.
The remote commander is not pointed
at the remote sensor.
Point the remote commander at the
sensor.
There is an obstacle between the
remote commander and the unit.
fae ee eA eS
The remote commander is too far from
the unit.
+—
Remove the obstacle.
Move closer.
Any operation is not possible.
The internal control program may not
run.
Turn
off
the
power
and
turn
it
on
again.
irs