CDX-G1200U/G1201U/G1202U/G1280UM
CDX-G1200U/G1201U/G1202U/G1280UM
1515
3-5. MAIN BOARD
1 two ground point screws
(PTT2.6 u 6)
2 two screws
(PTT2.6 u 8)
4 MAIN board
3 claw
3 claw
3 claw
Note: When the complete MAIN board is replaced, the destination
setting is necessary. Refer to “DESTINATION SETTING
METHOD” on page 4.
3-6. SERVICE POSITION
CD mechanism deck
CD mechanism deck
insulating
sheet
insulating sheet
stand
stand
main unit main unit
flexible flat cable (27 core)
(length: 150 mm)
Note 2:
Do not flexible flat cable (27 core) is
damaged by the edge of the chassis.
flexible flat cable (27 core)
(length: 150 mm)
Note 2:
Do not flexible flat cable (27 core) is
damaged by the edge of the chassis.
main unit
main unit
flexible flat cable (27 core)
(length: 150 mm)
flexible flat cable (27 core)
(length: 150 mm)
CD mechanism deck
Note 3:
CD mechanical deck should
not be placed vertically.
CD mechanism deck
Note 3:
CD mechanical deck should
not be placed vertically.
main unit
flexible flat cable (27 core)
(length: 150 mm)
CD mechanism deck
Note 4:
CD mechanical deck should
not be placed upside down.
OKOK
NG
NG
NG
Note 1: The service position below cannot be performed with the fl ex-
ible fl at cable (length: 80 mm) used with the unit. Refer to
“NOTE OF PERFORMING THE OPERATION CHECK” in
the servicing notes, and use a long fl exible fl at cable (length:
150 mm).
To Next Page
Loading...
