4
Getting Started
Playable discs on this unit
This unit can play CD-DA (also containing CD
TEXT) and CD-R/CD-RW (MP3/WMA files
(page 12)).
Switching the FM/MW tuning
step
The FM/MW tuning step is factory-set to the 50
kHz (FM)/9 kHz (MW) position. If the frequency
allocation system of your country is based on
200 kHz (FM)/10 kHz (MW) or 100 kHz (FM)/
10 kHz (MW) step, set the tuning step before
use.
This setting appears when turned off.
1 Press and hold the select button.
The setup display appears.
2 Rotate the control dial until “TUNER-
STP” appears, then press it.
3 Rotate the control dial to select from
“50K/9K,” “100K/10K” or “200K/10K,”
then press it.
Receivable frequency by selected frequency
setup:
FM 50 kHz: 87.50 MHz, 87.55 MHz, 87.60 MHz...
FM 100 kHz: 87.5 MHz, 87.6 MHz, 87.7 MHz...
FM 200 kHz: 87.5 MHz, 87.7 MHz, 87.9 MHz...
MW 9 kHz: 531 kHz, 540 kHz, 549 kHz...
MW 10 kHz: 530 kHz, 540 kHz, 550 kHz...
Canceling the DEMO mode
You can cancel the demonstration display which
appears during turning off.
1 Press and hold the select button.
The setup display appears.
2 Rotate the control dial until “DEMO”
appears, then press it.
3 Rotate the control dial to select
“DEMO-OFF,” then press it.
The setting is complete.
4 Press (BACK).
The display returns to normal reception/play
mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 13.
Type of discs Label on the disc
CD-DA
MP3
WMA
To Next Page
Loading...
