EasyManuals Logo

Sony CDX-M9900 Installation/Connections

Sony CDX-M9900
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Cautions
This unit is designed for negative ground 12 V
DC operation only.
Do not get the leads under a screw, or caught
in moving parts (e.g. seat railing).
Before making connections, turn the car
ignition off to avoid short circuits.
Connect the yellow and red power input
leads only after all other leads have been
connected.
Run all ground leads to a common ground
point.
Be sure to insulate any loose unconnected
leads with electrical tape for safety.
The use of optical instruments with this
product will increase eye hazard.
Notes on the power supply lead (yellow)
When connecting this unit in combination
with other stereo components, the connected
car circuit’s rating must be higher than the
sum of each component’s fuse.
When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in
the instructions.
The bracket 1 and the protection collar 3 are
attached to the unit before shipping. Before
mounting the unit, use the release keys 6 to
remove the bracket 1 and the protection
collar 3 from the unit. For details, see
“Removing the protection collar and the
bracket (5)” on the reverse side of the sheet.
Keep the release keys 6 for future use as
they are also necessary if you remove the
unit from your car.
Caut ion
Handle the bracket 1 carefully to avoid injuring
your fingers.
Note
Before installing, make sure t hat the catches on
both sides of t he bracket 1 are bent inwards 2 mm
(
3
/32 in). If the catches are straight or bent outwards,
the unit will not be installed securely and may spring
out.
AUDIO OUT
FRONT
SUB OUT
AUDIO OUT
REAR
VIDEO IN
©2004 Sony Corporation Printed in Korea
CDX-M9900
3-265-746-11 (1)
Installation/Connect ions
Installation/Connexions
FM/AM
Compact Disc
Player
32
Equipment used in illustrations (not supplied)
Appareils ut ilis dans les illustrations (non fournis)
Rear speaker
Haut-parleur arrière
Front speaker
Haut-parleur avant
Active subw oofer
Caisson de graves actif
54
CD/M D changer
Changeur de CD/ M D
× 4
1
B
VIDEO IN
BUS AUDIO IN/AUX IN
BUS CONTROL IN
VIDEO IN
BUS AUDIO IN/AUX IN
BUS CONTROL IN
Source selector*
Sélecteur de source*
XA-C30
* not supplied
non f ourni
A
× 2
Pow er amplifier
Amplificateur de puissance
6
Connection example (2)
Notes (2-A)
Be sure t o connect t he ground lead bef ore
connecting t he amplif ier.
If you connect an opt ional power amplif ier and do
not use t he built-in amplif ier, t he beep sound w ill
be deactivat ed.
Tip (2-B-
)
For connecting t wo or more CD/MD changers, t he
source select or XA-C30 (opt ional) is necessary.
Connection diagram (3)
1 To a metal surface of the car
First connect the black ground lead, then connect
the orange/w hit e st riped, yellow , and red pow er
input leads.
2 To the pow er antenna control lead or pow er
supply lead of antenna booster amplifier
Notes
It is not necessary t o connect t his lead if t here is
no power ant enna or ant enna boost er, or wit h
a manually-operat ed t elescopic ant enna.
When your car has a built-in FM /AM antenna in
the rear/side glass, see “ Notes on t he cont rol
and power supply leads.”
3 To AM P REM OTE IN of an optional pow er
amplifier
This connection is only f or amplifiers. Connect ing
any other syst em may damage t he unit .
4 To the interface cable of a car telephone
5 To a car’s illumination signal
Be sure t o connect the black ground lead to a
met al surface of t he car f irst .
6 To the +12 V pow er terminal w hich is energized
in the accessory position of the ignition key
sw itch
Notes
If t here is no accessory position, connect t o t he
+12 V pow er (bat t ery) t erminal which is
energized at all t imes.
Be sure t o connect the black ground lead to a
met al surface of t he car f irst .
When your car has a built-in FM /AM antenna in
the rear/side glass, see “ Notes on t he cont rol
and power supply leads.”
7 To the +12 V pow er terminal w hich is energized
at all times
Be sure t o connect the black ground lead to a
met al surface of t he car f irst .
8 To the parking brake sw itch cord
Catch
1
DVD player DVX-11A
Lecteur DVD DVX-11A
7
2
1
Rotary commander RM -X4S
Satellite de commande RM -X4S
Downloaded from: https://www.usersmanualguide.com/

Other manuals for Sony CDX-M9900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sony CDX-M9900 and is the answer not in the manual?

Sony CDX-M9900 Specifications

General IconGeneral
BrandSony
ModelCDX-M9900
CategoryCar Receiver
LanguageEnglish

Related product manuals