Basic Operations
11
GB
3 Start recording.
Press z on deck B (N is depressed
automatically).
Use these buttons for additional operations
Notes
• During recording, do not
press M, m or PLAY
on deck A as this causes
excessive wow and flutter.
• While recording from the
built-in microphone (MIC),
no sound comes from the
speakers or the headphones.
• When you connect the
microphone to the MIX
MIC jack, you cannot
record from the built-in
microphone.
Tips
• Adjusting the volume or
selecting the audio
emphasis (see page 18) will
not affect the recording
level.
• If the MW program makes
a whistling sound after
you've pressed z in step 3,
set the ISS•FM MODE
(Interference Suppress
Switch) at the rear to the
position that most decreases
the noise.
• For the best results, use the
AC power as a power
source.
• To erase a recording,
proceed as follows:
1 Insert the tape into deck
B.
2 Disconnect the audio
source if connected to the
TV/LINE IN jack at the
rear.
3 Set FUNCTION to TV/
LINE IN.
4 Press z on deck B.
xZ
X
n
To Press
stop recording xZ on deck B
pause recording X on deck B
Press the button again to resume
recording.
Deck B
xZ X
To Next Page
Loading...
