8
CFD-E90
The Timer
19
Before you set the clock, connect the power
source.
1 Hold down CLOCK/SLEEP/TIMER
until CLOCK appears in the display.
The hour digit flashes.
2 Turn the jog dial to set the current hour.
Then press ENTER.
The minute digits flash. Set the minutes
by turning the jog dial until the correct
minute is displayed.
The Timer
Setting the clock
— —:— — indication appears in the display
until you set the clock.
3 Press ENTER.
The clock starts from 00 seconds.
Tip
The time display system: 12-hour system
AM 12:00 = midnight
PM 12:00 = noon
CLOCK/SLEEP/TIMER
ENTER Jog dial
To Next Page
Loading...
