EasyManua.ls Logo

Sony CSD-MP100 - Printed Wiring Board - CD Section

Sony CSD-MP100
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CSD-MP100
2626
1
A
B
C
D
E
F
G
H
I
J
234567891011
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
Common Note on Schematic Diagrams:
All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
All resistors are in and
1
/
4
W or less unless otherwise
specified.
f
: internal component.
C : panel designation.
A : B+ Line.
H : adjustment for repair.
•Total current is measured with no cassette installed.
•Power voltage is dc 9V and fed with regulated dc power
supply from battery terminal.
•Voltages are taken with a VOM (Input impedance 10 M).
Voltage variations may be noted due to normal produc-
tion tolerances.
•Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
Circled numbers refer to waveforms.
Signal path.
F : FM
f : AM
E : PB
a : REC
J : CD
•Abbreviation
CND : Canadian model.
E4 : AC 200-240V area in E model.
E15 : AC 220-240V area in E model.
TW : Taiwan model.
AUS: Australian model.
SP : Singapore model.
KR : Korean model.
Common Note on Printed Wiring Boards:
X : parts extracted from the component side.
Y : parts extracted from the conductor side.
x : parts mounted on the conductor side.
f
: internal component.
: Pattern from the side which enables seeing.
•Abbreviation
CND : Canadian model.
E4 : AC 200-240V area in E model.
E15 : AC 220-240V area in E model.
TW : Taiwan model.
AUS: Australian model.
SP : Singapore model.
KR : Korean model.
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
• Refer to page 25 for Circuit Boards Location.
6-5. PRINTED WIRING BOARD — CD SECTION — • Refer to page 26 for Common Note on Printed Wiring Boards.

Related product manuals