105
DSC-L1 2-186-455-11(1) [OpenType FONT]
Troubleshooting
Message Meaning/Corrective Action
For "InfoLITHIUM" battery
only
• The battery pack is not the “InfoLITHIUM” type.
Image size over
• You are playing back an image of a size that cannot be played back on your camera.
Cannot divide
• The movie is not long enough to be divided (about more than two seconds).
• The file is not a movie.
Invalid operation
• You are playing back a file that was created on equipment other than this camera.
• The battery level is low or zero. Charge the battery pack (page 13). Depending on the conditions of use or the type
of battery pack, the indicator may flash even though there are still 5 to 10 minutes of remaining battery time left.
• Camera shake may occur due to insufficient light. Use the flash, mount the camera on a tripod, or otherwise
secure the camera in place.
Turn the power off and on
again
• A problem with the lens caused an error.
640(Fine) is not available
• 640(Fine) size movies can be recorded only using “Memory Stick PRO Duo”. Insert a “Memory Stick PRO Duo”
or set the image size to other than [640(Fine)].
Enable printer to connect
• [USB Connect] is set to [PictBridge], however the camera is connected to a non-PictBridge compliant device.
Check the device.
• Depending on the circumstances, the connection may not be established. Disconnect and connect the USB cable
again. If an error message is indicated on the printer, refer to the operating instructions supplied with the printer.
Connect to device
• You tried to print images before the printer connection was established. Connect to a PictBridge compliant printer.
No printable image
• You tried to execute [DPOF image] without checking the mark.
• You tried to execute [All In This Folder] while selecting the folder that stores only movies. You cannot print
movies.
Printer busy
• Since the printer is busy, it cannot receive print requests. Check the printer.
Paper error
• A paper error occurred, such as paper-out, paper-jam, etc. Check the printer.
Ink error
• An ink error has occurred in the connected printer, or the ink is low. Check the printer.
Printer error
• The camera received an error from the printer. Check the printer, or check if the image you want to print is
corrupted.
• The data transmission to the printer may not be completed yet. Do not disconnect the USB cable.
To Next Page
Loading...
