Sony Cyber-shot DSC-T1 - Identifying Camera Components; Camera Exterior Parts Identification

2. DISASSEMBLY
2. DISASSEMBLY
DSC-T1
2-3 2-4
2-2. SERVICE POSITION
SY-95
1
3
2
4
SY-95
SY-95
SY-95 board
CN-198 board
MS-148 board
Control switch block (PW-125)
Lens section
AC power
adaptor
AC IN
CN701
CN402
CN702
CN704
CN705
FP-695 board (21P)
CCD block
assembly (33P)
FP-693 flexible board (16P)
LCD unit (ACX500EN-J),
Block light guide plate
(25P)
CN703
S401 LENS COVER switch (Note1)
FP-690
flexible board (19P)
ST-86 board
The power capacitor of the flash unit is charged up to 315 V maximum. If you touch
the capacitor terminal that is charged to high voltage, you will receive an electric
shock. This high voltage is not discharged even if you turned off the main power
of this set, and it residues. Discharge the residual voltage referring to the service
note (page 1-1).
Note :
[SERVICE POSITION TO CHECK THE SY-95 BOARD]
Note1: By using an adhesive tape, press the LENS COVER switch (S401).
Note2: When checking the VIDEO AMP (SY-95 board IC302) or the USB circuit, connect the cradle.
1
2
3
1
2
3
4
2
1
5
2
3
4
1
5
1
2
3
2
1
5
2
1
1
1
3
1
2
3
1
2
3
9
5
4
6
7
8
2
3
1
Mode knob