Sony DCX-930 - Page 11

@ Lens mount
Attach here an optional zoom lens, microscope adaptor
or endoscope adaptor depending on the intended
application of the camera.
@ Mounting screw holes (one in the top of the
camera body and another in the bottom)
To mount the camera on a building wall, ceiling or the
like, or on a tripdod, use either of these holes and a
U1/4” -20 UNC screw.
© MENU (menu recall) button
Pressing this button recalls an operational settings menu
(called as the menu in this manual; see Chapter 4), which
will be displayed on the screen of the monitor connected
to the camera. Pressing again the button makes the menu
disappear from the monitor screen.
@ DISPLAY/BARS (menu display control/color
bars output) button
With the menu displayed: each press of this button
switches the number of display lines between 1 and 8.
With the menu not displayed: pressing this button makes
the color bars signal be output.
@ FUNCTION UP and DOWN (menu scroll) buttons
UP button: scrolls the menu display upwards.
DOWN button: scrolls the menu display downwards.
© DATA UP/WHITE (higher setting selection/white
balance adjustment) button
With the menu displayed: changes the setting value for
the higher.
With the menu not displayed: activates the automatic
white balance adjustment function.
Chapter 1
@ LENS connector
When using a 2/s-inch zoom lens, connect the lens cable
to this connector.
For a '-inch zoom lens, there is no necessity to use this
connector.
@ DATA DOWN/BLACK (lower setting selection/
black balance adjustment) button
With the menu displayed: changes the setting value for
the lower.
With the menu not displayed: activates the automatic
black balance adjustment function.
© CCU (camera control unit) connector
Connect a camera control unit such as the CCU-M3/
M3P/M7/M7P to this connector.
Chapter 1 introduction (| 1-5(E)