DSC-H10_L2
HELP
THE METHOD OF ATTACHMENT OF PL-048 FLEXIBLE BOARD
HELP05
AF Spacer
Push it to
AF sensor.
It should not be
out of the flexible
cable form.
PL-048 Flexible Board
PL-048 Flexible
Board
Be careful not to touch
the copper leads
or contacts.
Bosses
Claws
Claw
PL Insulating Sheet
AF Holder
Mold of
plunger
Put PL Insulating Sheet
by pushing it in the arrow
direction.
Put it by picking this point
with tweezers.
ST Assy
Pin
1 Attach the AF spacer as shown in figure.
3 Attach the PL insulating sheet as shown in figure.
2 Install the PL-048 flexible board in the AF holder.
4 Install the PL-048 flexible board, AF holder
in the ST assy as shown in figure.
5 Install the screw.
Bosses
Screw
Boss
To Next Page