Note:
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part
15
of
the
FCC Rules.
These limits are designed
to
provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment
off
and on, the user
is encouraged to try to correct the
interference by one or more
of
the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radiorrV technician for help.
The supplied interface cable must be used
with the equipment in order to comply with
the limits for a digital device pursuant to
Subpart B
of
Part
15
of
FCC Rules.
4
;;IIII,lill,III!lllllli'l~i
Notice
for
the
customers
in
the
countries
applying
EU
Directives
The manufacturer
of
this product is Sony
Corporation,
1-7-1
Konan Minato-ku
Tokyo, 108-0075 Japan. The Authorized
Representative for EMC and product safety
is Sony Deutschland GmbH, Hedelfinger
Strasse 61, 70327 Stuttgart, Germany. For
any service or guarantee matters please
refer to the addresses given in separate
service or guarantee documents.
This product has been tested and found
compliant with the limits set out in the
EMC Directive for using connection cables
shorter than 3 meters (9.8 feet).
Attention
The electromagnetic fields at the specific
frequencies may influence the picture and
sound
of
this unit.
Notice
If static electricity or electromagnetism
causes data transfer to discontinue midway
(fail), restart the application
or
disconnect
and connect the communication cable
(USB, etc.) again.
To Next Page
Loading...
Need help?
General
