•
PIN method – your device creates a random PIN (Personal Identification Number),
which you enter on the WPS-supported device.
To connect to a Wi-Fi network using a WPS button
1
From the Home screen, tap .
2
Find and tap Settings > Wi-Fi.
3
Turn on Wi-Fi if it is not already on.
4
Tap , then tap Advanced > WPS Push Button, then press the WPS button on
the WPS-supported device.
To connect to a Wi-Fi network using a WPS PIN
1
From your Home screen, tap .
2
Find and tap Settings > Wi-Fi.
3
Turn on Wi-Fi if it is not already on.
4
Tap
> Advanced > WPS PIN Entry.
5
On the WPS-supported device, enter the PIN that appears on your device.
Sharing your mobile data connection
You can share your mobile data connection with other devices in several ways:
•
USB tethering – share your mobile data connection with a single computer using a
USB Type-C™ cable.
•
Bluetooth® tethering – share your mobile data connection with up to four other
devices via Bluetooth®.
•
Portable hotspot – share your mobile data connection simultaneously with up to 10
other devices via Wi-Fi, including devices that support WPS technology.
To share your data connection using a USB cable
1
Connect your device to a computer, using the USB cable that came with it.
2
From your Home screen, tap .
3
Find and tap Settings > More > Tethering & portable hotspot.
4
Tap the USB tethering slider, then tap OK if prompted. is displayed in the
status bar once you are connected.
5
To stop sharing your data connection, tap the USB tethering slider or
disconnect the USB cable.
You cannot share your device's data connection and SD card over a USB cable at the same
time.
To share your mobile data connection with another Bluetooth® device
1
Make sure that your device and the other Bluetooth® device are paired with
each other and that mobile data traffic is activated on your device.
2
Your device: From your Home screen, tap .
3
Find and tap Settings > More > Tethering & portable hotspot and then tap the
Bluetooth tethering slider to enable the function.
4
Bluetooth® device: Set up the device so that it obtains its network connection
using Bluetooth®. If the device is a computer, refer to the relevant instructions
to complete the setup. If the device runs on the Android™ operating system,
tap the settings icon beside the name of the device that it is paired with under
Settings > Bluetooth > Paired devices, then mark the Internet access checkbox.
5
Your device: Wait for
to appear in the status bar. Once it appears, the setup
is complete.
6
Tap the Bluetooth tethering slider again to disable the function.
The
Bluetooth tethering function is turned off every time you turn off your device or turn off the
Bluetooth® function.
48
This is an internet version of this publication. © Print only for private use.
To Next Page
Loading...
