95
“Memory Stick” Operations
Using a “Memory Stick” – introduction
Inserting a “Memory Stick”
Insert a “Memory Stick” in the “Memory Stick” slot as far as it can go with the v mark
facing up as illustrated.
Ejecting a “Memory Stick”
Slide MEMORY RELEASE in the direction of the arrow.
While the access lamp is lit or flashing
Do not shake or strike your camcorder because your camcorder is reading the data from
the “Memory Stick” or recording the data on the “Memory Stick.” Do not turn the
power off , eject a “Memory Stick” or remove the battery pack. Otherwise, the image
data breakdown may occur.
If “ MEMORYSTICK ERROR” is displayed
The “Memory Stick” is corrupted. If this occurs, use another “Memory Stick.”
“Memory Stick” slot
MEMORY RELEASE
Access lamp
To Next Page
Loading...
Need help?
General