12)
Use
only
with
the cart, stand, tripod, bracket, or
table
specified by the
manufacturer, or
sold
with the apparatus. When a
cart
is
used, use
caution when moving the cart/apparatus combination
to
avoid injury
from tip-over.
13)
Unplug
this apparatus during
lightning
storms or when unused for
long
periods
of
time.
14)
Refer
all servicing
to
qualified service
personnel.
Servicing
is
required
when the apparatus
has
been damaged in any way, such
as
power-
supply
cord or plug
is
damaged, liquid
has been
spilled
or objects
have
fallen
into the apparatus, the apparatus has been exposed
to
rain or moisture, does
not
operate
normally,
or has been dropped.
The
following
FCC
statement
applies only
to
the version
of
this
model
manufactured
for
sale
in the
U.S.A.
Other
versions may not
comply
with
FCC
technical regulations.
NOTE:
This equipment
has
been tested and found
to
comply with the limits
for
a
Class
B
digital device, pursuant to Part
15
of
the
FCC
Rules.
These
limits
are designed
to
provide
reasonable
protection against
harmful
interference in a residential installation. This equipment generates, uses
and
can
radiate radio frequency energy and,
if
not
installed
and used in
accordance with the instructions, may cause harmful
interference
to
radio communications.
However, there
is
no guarantee
that
interference
will
not
occur
in
a
particular installation.
If
this equipment does cause
harmful interference
to
r~dio
or
television
reception, which can be determined by turning the
equ1pment
off
and on, the user
is
encouraged
to
try
to
correct the
interference by one or more
of
the following
measures:
- Reorient or
relocate
the receiving antenna.
-
Increase
the separation between the equipment and receiver.
- Connect
the equipment into
an
outlet
on a circuit different from
that
to
which the receiver
is
connected.
-
Consult the
dealer
or
an
experienced radio/TV technician for help.
Properly shielded
and grounded cables
and connectors must
be
used for
connection
to
host computers
and/or
peripherals
in
order
to
meet
FCC
emission limits.
CAUTION
You are cautioned that any changes or modifications
not
expressly
approved in this
manual could
void your authority
to
operate this
equipment.
This equipment must
not
be
co-located or operated in conjunction with
any other antenna or transmitter.
This equipment complies
with
FCC
radiation exposure
limits
set forth for
an
uncontrolled
environment and meets the
FCC
radio frequency
(RF)
Exposure
Guidelines.
This equipment should be
installed
and operated
keeping the radiator at
least 20cm
or more away from person's body
(excluding
extremities: hands, wrists, feet and
ankles).
Compliance
with
FCC
requirement
15.407(
c)
Data transmission
is
always
initiated by software, which
is
the passed
~own
through the
MAC,
through the
digital
and
analog
baseband, and
fmally
to
the
RF
chip. Several special packets are initiated by the
MAC.
These are the
only
ways the digital
baseband portion
will
turn on the
RF
transmitter, which it then turns
off
at the end
of
the packet. Therefore,
the transmitter
will
be on
only while one
of
the aforementioned packets
is
being transmitted.
In
other words, this device
automatically
discontinue transmission in
case
of
either absence
of
information
to
transmit or
operational failure.
Frequency
Tolerance: ±20 ppm or
less
continued
---
3us
To Next Page
Loading...
