Sony HT-ST9 - Speaker Angle and Wall Mounting Instructions

Modifying
the
Angle
of
the
Bar
Speaker
You can
modify
the
angle
of
the
Bar
Speaker by attaching
the
stands
on
the
bottom
of
the Bar Speaker.
You
can
attach
the
stands on
the
bottom
of
the Bar Speaker
as
shown
below.
mTml
•
We
recommend
that
you use the system
without
attaching stands
if
you
will
be
listening
to
High-Resolution Audio.
•
When you
mount
the
Bar
Speaker on the
wall,
detach the stands
beforehand.
Attach the stands to both sides
of
the
bottom
of
the Bar Speaker
using the supplied screws.
Tip
The
stand shape differs
for
the right and
left
sides.
Check
the
"R"
or
"L"
mark engraved on the stand before attaching it.
36US
Mounting
the
Bar
Speaker
on
a
Wall
You can
mount
the
Bar Speaker on a
wall.
mTml
• When you
mount
the
Bar
Speaker on the
wall,
detach the stands
beforehand (page
36).
•
Prepare screws (not supplied)
that
are
suitable
for
the
wall material
and
strength.
As
a plasterboard
wall
is
especially fragile,
attach the screws
securely
to
two
studs
in
the
wall
beam.
Install the Bar Speaker
horizontally,
hung by screws
in
studs in a continuous flat section
of
the
wall.
• Have the
installation
done by a Sony dealer
or
licensed
contractor and
pay
special
attention
to
safety during the
installation.
•
Sony
shall not be
held responsible
for accidents or damage caused by
improper installation,
insufficient
wall
strength, improper screw
installation
or
natural disaster, etc.
1
Prepare screws (not
supplied)
that
are suitable for
the
holes
on
the
rear
of
the Bar Speaker.
~
4
mm (3/16 in)
~ ~
More than
30
mm
(1
3/16 in)
4.6mm
K(3/16in)
.1
1.
10
mm
(13/32 in)
Hole on the rear
of
the Bar Speaker