Hint
Once the QR code has been read, this product's SSID (DIRECT-xxxx) and password are registered
to the smartphone. This enables you to easily connect the smartphone to the product via Wi-Fi at a
later date by selecting the SSID. (Set [Ctrl w/ Smartphone] to [On] in advance.)
Note
Radio wave interference may occur as Bluetooth communications and Wi-Fi communications use the
same frequency band. If your Wi-Fi connection is unstable, it may be improved by turning off the
Bluetooth function of the smartphone. If you do this, the location information interlocking function is
not available.
If you cannot connect your device to this product using the [One-touch(NFC)] function or QR code,
use the SSID and password.
[233] Using wireless functions Connecting this product and a Smartphone
When a message is displayed, select [OK] again.
Read the QR code displayed on the monitor of this product with the smartphone.
Once the QR code has been read, a message [Connect with the camera?] will be
displayed on the monitor of the smartphone.
4
Select [OK] on the smartphone screen.
The smartphone is connected to the product.
You can shoot an image using remote control while checking the composition of the
image on the smartphone screen.
5
To Next Page
Loading...
