Sets the recording method for the time code.
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1. MENU→ (Setup) → [TC/UB Settings] → [TC Preset], then press in
the center of the control wheel.
2. Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
*
When [24p] is selected, you can select the last two digits of the time code
in multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3. Set the other digits following the same procedure as in step 2, then press
in the center of the control wheel.
How to reset the time code
Reset the time code using the infrared remote control RMT-845 (sold separately),
which is available at Sony service facilities.
Only the following settings can be changed using the RMT-845. You cannot
perform any other operations.
Reset time code
Start/stop movie recording
How to set the user bit (UB Preset)
1. MENU→ (Setup) → [TC/UB Settings] → [UB Preset], then press in
the center of the control wheel.
2. Turn the control wheel and select the first two digits.
3. Set the other digits following the same procedure as in step 2, then press
in the center of the control wheel.
How to reset the user bit
To Next Page
