You can select a value between −20 and +20. Selecting a positive value
shifts the autofocused position away from the product. Selecting a
negative value shifts the autofocused position closer to the product.
Note
It is recommended that you adjust the position under actual shooting conditions.
When you attach a lens for which you have already registered a value, the
registered value appears on the screen. [±0] appears for lenses for which a
value has not yet been registered.
If [−] is displayed as the value, then a total of 30 lenses have been registered
and no new lens can be registered. To register a new lens, attach a lens for
which the registration can be erased, and set its value to [±0], or reset the
values of all the lenses using [Clear].
The [AF Micro Adj.] supports Sony, Minolta, or Konica-Minolta lenses. If you
perform [AF Micro Adj.] with lenses other than the supported lenses, the
registered settings for the supported lenses may be affected. Do not perform
[AF Micro Adj.] with an unsupported lens.
You cannot set [AF Micro Adj.] individually for a Sony, Minolta, and Konica-
Minolta lens of the same specification.
[80] How to Use Using shooting functions Adjusting the focus
Disp. cont. AF area
You can set whether or not to display the focus area that is in focus when [Focus
Area] is set to [Wide] or [Zone], in [Continuous AF] mode.
1. MENU → (Custom Settings) → [Disp. cont. AF area] → desired setting.
Menu item details
On (default setting):
Displays the focus area that is in focus.
Off:
Does not display the focus area that is in focus.
To Next Page
Loading...
