- 16 -
SE2
RM-ED009
TT mode is available by setting the TV for operation in Service Mode [ As shown on Page 14 ] , OSD ‘TT’ appears. The functions described
below are available by selecting the two numbers. To release the ‘Test mode 2’, press 00, 10, 20 ... twice or switch the TV set into Stand-by
mode. In ‘TT Menu’ mode, it is possible to remove the Menu from the screen by pressing the Speaker Off button once. Pressing the Speaker
OFF button a second time will cause the Menu to reappear. The function is kept even when the menu is not displayed on screen !!.
3-2. TT MODE
00
'TT' mode off
03
Set volume to 35%
04
Set volume to 50%
05
Set volume to 65%
06
Set volume to 80%
07
Ageing mode on
08
Shipping Condition
09
WB adj initial conditions
14
Teletext centered
19
Factory toggle mode (on/off)
27
CBA mode toggle (ON/OFF)
31
ECS mode toggle (ON/OFF)
32
Set BCN channels preset
33
Connect/Disconnect EDID write o general I2C bus
34
HDMI log enable/disable
35 Hotel mode toggle
37
PC Monitor mode toggle
38 OTRUM mode
39
Enable Digital Test
41 Re-initialise NVM
43
Select Dual Sound "A"
44
Select Dual Sound "B"
45
Select Dual Sound "Mono"
46
Select Dual Sound "Stereo"
48
Set NVM as non-virgin
49
Set NVM as virgin
51
Hybrid/ALPS tuner selection
52
Temperature sensor enable/disable
53
Digital/Analog model
54
Watchdog toggle
55
Audio delay toggle
56
Set Bravia Model enable/disable
57
MSP Auto Carrier Mute function enable/disable
58
Chip select toggle
59
Visual I2C toggle
61
Set 15" 4:3 XGA settings
62
Set 20" 4:3 VGA settings
63
Set 20" WXGA settings
64
Set 23" WXGA settings
65
Set 26" WXGA settings
66
Set 32" WXGA settings
67
Set 37" WXGA settings
68
Set 40" WXGA settings
71 Auto AGC
72
AM from baseband (AFRIC dem) or fromRF (MSP
dem)
73 HDMI number of inputs (0 to 2)
74
DDC enable
75
Set centred balance
76 Set volume to max
77
Set volume to min
78
Set balance full left
79
Set balance full right
81
Digital BER display
82
Digital Service menu
83
Digital colour bar output from DENC
84
TS CI path through
85
Digital tuner power down (Only 1 power cycle,default
is no power down)
86
Switch between two digital SW banks
87 Local keys test
88
Digital shipping conditions (Clear tune database)
89 LED test
91
OAD enable/disable toggle
92
TS CI path through with Reed Solomon off
94
Spread spectrum toggle
96
Digital debug output enable/disable
97
Digital 656 output enable/disable
98
Digital auto reset function enable/disable
99
Display error and working time menu
To Next Page
Loading...
Need help?
General