42
The following checklist will help you remedy
problems you may encounter with your unit.
Before going
through
the checklist below,
check the connection and operating
procedures.
For details
on
using the fuse and removing the
unit from the dashboard, refer to the
installation/ connections manual supplied with
this unit.
If
the problem
is
not
solved, visit the support
site
on
the back cover.
No
power
is
being supplied
to
the unit.
~
Check the connection or fuse.
~
If the unit is
turned
off
and
the display
disappears, the unit cannot be operated with
the remote commander.
-
Turn
on
the unit.
The
power
antenna (aerial) does not extend.
~
The power
antenna
(aerial) does not have a
relay box.
No sound.
~
The A
TT
function
is
activated,
or
the
Telephone ATT function (when the interface
cable
of
a car telephone
is
connected to the
ATT lead)
is
activated.
~
The position
of
the fader control
((FADER"
is
not set for a 2-speaker system.
No beep sound.
~
The beep
sound
is
cancelled (page 34).
~
An optional power amplifier
is
connected and
you are
not
using the built-in amplifier.
The contents
of
the
memory have been
erased.
~
The power supply lead
or
battery has been
disconnected
or
not
connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position
of
the
ignition
is
switched.
~
The leads are
not
matched correctly with the
car's accessory power connector.
During playback or reception,
demonstration mode starts.
~
If
no operation
is
performed for 5 minutes
with ((DEMO-ON" set, demonstration
mode
starts.
- Set ((DEMO-OFF" (page 34).
The display disappears from/does
not
appear in
the
display window.
~
The
dimmer
is
set to ((DIM-ON" (page 35).
~
The display disappears if you press
and
hold
(SOURCE/OFF).
- Press
(SOURCE/OFF)
on the unit until the
display appears.
~
The connectors are dirty (page 40).
The Auto Off function does not operate.
~
The unit
is
turned
on. The Auto
Off
function
activates after turning off the unit.
-
Turn
off the unit.
Stations cannot be received.
The sound
is
hampered by noises.
~
The connection
is
not correct.
- Connect an REM OUT lead (blue/white
striped)
or
accessory power supply lead (red)
to the power supply lead
of
a car's
antenna
(aerial) booster (only when your car
has
a
built-in radio antenna (aerial) in the rear/
side glass).
- Check the connection
of
the car
antenna
(aerial).
-
If
the auto antenna (aerial) will
not
go up,
check the connection
of
the power
antenna
(aerial) control lead.
Preset tuning
is
not possible.
~
Store the correct frequency in the memory.
~
The broadcast signal
is
too weak.
Automatic tuning
is
not possible.
~
The broadcast signal
is
too weak.
- Perform manual tuning.
PTY
displays"--------."
~
The current station
is
not an
RDS
station.
~
RDS
data has not been received.
~
The station does not specify the program type.
To Next Page
Loading...
