The
disc cannot be
loaded.
~
Another disc
is
already loaded.
~
The disc has been forcibly inserted upside
down
or
in the wrong way.
The
disc does
not
play
back.
~
Defective
or
dirty disc.
~
The CD-Rs/CD-RWs are not for audio use
(page 38).
MP3/WMA/AAC files
cannot be
played
back.
~
The disc
is
incompatible with the MP3/WMA/
AAC format and version. For details
on
playable discs
and
formats, visit the support
site.
MP3/WMA/AACfiles
take
longer
to
play
back
than
others.
~
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree
structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The
display items
do
not
scroll.
~
For discs with very many characters, those may
not scroll.
~
"AUTO SCR"
is
set to
"OFF."
-
Set "A.SCRL-ON"
(page 35).
- Press and hold (
DSPL)
(SCRL).
The sound skips.
~
Installation
is
not
correct.
- Install the unit at an angle
of
less than
45°
in
a sturdy part
of
the car.
~
Defective
or
dirty disc.
You cannot play
back items via a
USB
hub.
~
This unit cannot recognize
USB
devices via a
USB
hub.
Cannot play back items.
~
A
USB
device does
not
work.
- Reconnect it.
A
USB
device takes
longer
to
play
back.
~
The
USB
device contains files with a
complicated tree structure.
The sound
is
intermittent.
~
The
sound
may be intermittent at a high-bit-
rate
of
more than
320
kbps.
Pandora
0
connection
is
not
possible.
~
Shut
down the
Pandora®
application
on
the
mobile device, and then launch again.
The connecting device cannot detect this
unit.
~
Before the pairing
is
made, set this unit to
pairing standby mode.
~
While connected to a Bluetooth device, this
unit cannot be detected from another device.
- Disconnect the current connection
and
search for this unit from another device.
~
When
the device pairing
is
made, set the
Bluetooth signal output to
on
(page 23, 24, 35).
Connection
is
not possible.
~
The connection
is
controlled from one side
(this unit
or
Bluetooth device),
but
not
both.
- Connect to this unit from a Bluetooth device
or
vice versa.
~
Check the pairing and connection procedures
in the manual
of
the other device, etc.,
and
perform the operation again.
The
name
of
the
detected device does
not
appear.
~
Depending
on
the status
of
the other device, it
may not be possible to obtain the name.
No ri ngtone.
~
Adjust the volume by rotating the control dial
while receiving a call.
~
Depending
on
the connecting device, the
ringtone may not be sent properly.
-
Set "RINGTONE"
to
"1"
(page 22).
The talker's voice
volume
is
low.
~
Adjust the volume level.
43
To Next Page
Loading...
