32GB
Messages
The following messages may appear or flash
during operation.
INVALID: The selected operation could be
invalid.
READ
Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR
Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO DISC
Insert a disc containing playable files
(page 26).
CD NO MUSIC
Insert a disc containing playable files
(page 26).
CD PUSH EJT: The disc could not be ejected
properly.
Press (eject).
or : The beginning or the end
of the disc has been reached.
For USB device playback:
HUB NO SUPRT: USB hubs are not
supported.
IPD STOP: iPod playback has finished.
Operate your iPod/iPhone to start
playback.
NOT SUPPORT - ANDROID MODE
A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 21).
USB ERROR
Connect the USB device again.
USB NO DEV
Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC
Connect a USB device containing playable
files (page 26).
USB NO SUPRT
For details on the compatibility of your
USB device, visit the support site on the
back cover.
USB OVERLOAD: The USB device is
overloaded.
Disconnect the USB device, then press SRC
to select another source.
The USB device has a fault, or an
unsupported device is connected.
For DAB/DAB+ radio reception:
NO DATA
There is no DAB station for the selected
program type.
– Press (back).
NO INFO
There is no label information for the
current DAB station.
NO STATION: The DAB signal cannot be
received.
Perform an auto tune (page 11).
Check the connection of the DAB antenna
(aerial).
Check that [ANT-PWR] is set to [ON]
(page 21).
RECEIVING
The DAB source is selected and the unit is
waiting to receive a station.
To Next Page
