Sony MEX-R5 - Page 2

Warning
To
prevent fire
or
shock hazard,
do
not
expose the unit to rain or moisture.
To
avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
CAUTION
The
use
of
optical instruments
with this
product
will increase eye hazard. As the laser beam used
in this CD/DVD player is harmful to eyes,
do
not
attempt to disassemble the cabinet.
Refer servicing
to
qualified personnel only.
CAUTION
-
Las
er
ra
diatio
n wh
en
ope
n.
DO NOT
STA
RE
INTO
BE
AM
.
This label is located on the
drive
unit's internal
1
chassis.
2
Warning if your car's ignition has no
ACC position
After turni
ng
the ignition off, be
sure
to press
and hold
(OFF)
on
the
uniL
until the display
disappears.
Otherwise, the display does not turn
off
and
this causes
battery drain.
This equipment has been tested and found
to
comply
with
the limits for a Class B digit
al
devke,
pursuant to
Part
15
of
the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference
in
a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and,
if
not installed and used
in
accordance with the instructions, may cause
harmful interference
to
radio communications.
However, there is no guarantee that interference
wiU
not occur
in
a particular installation.
lf
this
equipment does cause harmful interference to
radio
or
television reception, which can be
determined by turning the equipment
off
and on,
the user is encouraged
to
try to correct the
interference
by
one
or
more
of
the foJlowing
measures:
- Reorient
or
relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is
connected.
- Consult the dealer
or
an experienced
radiorrV
technician for help.
You are cautioned that any changes
or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Operation is subject to the following two
conditions;
- this device may
not
cause interference.
- this device must accept any interference,
including interference that may cause
undesired operation
of
the device.
Properly
shielded and grounded cabl
es
and
connectors must be used
in
order to meet FCC
emission limits.