48
GB
Mixing and recording sounds
You can “mix” sounds by playing one of the
components and singing or speaking into a
microphone (not supplied).
The mixed sound can be recorded on a tape.
Use buttons on the unit for the operation.
1 Prepare the source you want to mix.
2 Load a recordable tape in deck B, and
press TAPE A/B repeatedly to select
deck B.
3 Press PLAY MODE repeatedly to select
“g”
to record on one side. Select
“j” (or “RELAY”) to record on both
sides.
4 Press hH repeatedly to select
recording side, then press x.
If you select both sides recording or front
side recording, press hH to light up the
N indicator, then press x. If you record
on the reverse side, press hH again to
light up the n indicator, then press x.
5 Press the function button of the source
you want to record (e.g., DVD).
When you want to record from TAPE A,
press TAPE A/B repeatedly until TAPE A
is selected.
6 Press REC PAUSE/START.
Deck B stands by for recording.
“REC” flashes.
7 Press REC PAUSE/START, and then
start singing, speaking or playing the
desired source.
Recording starts.
To stop recording
Press x.
Notes
• When you select any function other than DVD in
step 5, karaoke and key control settings are canceled.
• Microphone does not function while the tape deck is
performing the AMS operation (page 41).
Tips
• If acoustic feedback (howling) occurs, move the
microphone away from the speakers or change the
direction of the microphone.
• If you want to record your voice through the
microphone only, you can do so by selecting the
DVD function and not playing a disc.
• When high level sound signals are input, the system
automatically adjusts the recording level to prevent
distortion of the recorded sound signal (Auto Level
Control function).
To Next Page
Loading...